Wizard tower not firing

Quote:

---

Originally Posted by Icekool17

it's not that simple.

It targets a unit, and takes x amount of time to fire. The unit is killed during that time, and so no shot is fired.
If you then say let it fire anyway, where the unit was...then you'll get complaints that the Wizard is being a ♥♥♥♥ and not shooting properly. I.e. whilst it fired at the non-existant target another target it could have fired at is busily running amok, doing damage left right and centre. It now has to take x amount of time to fire again, taking longer than it would have done if it hadn't have fired before.

It's the same with the Archers and cannons...they can often shoot twice at a target, even though the first shot killed them. Yes it's wasting bullets/time in doing so...but it doesn't know that the target is dead when it fires it's 2nd shot. If it waited to see if it was dead before firing the next there would be a lot of complaints.

---

This makes no sense. We know the reason the tower/mortars arent firing. The problem is it is stupid. No one firing a mortar would stop firing it because one out of twenty or fifty troops died. It should be fixed.

sorry if posted to wrong category*

problem with x-bow, when it shoting another tower(as wizard or mortar) not shoting even if their attack range is offensive.

maybe next patch, make that the tower continued their fire on the target even if it has already been killed

Quote:

---

Originally Posted by Berg

This makes no sense. We know the reason the tower/mortars arent firing. The problem is it is stupid. No one firing a mortar would stop firing it because one out of twenty or fifty troops died. It should be fixed.

---

It makes perfect sense!

It being stupid is not a valid reason.
It using time to target and then time to fire is.

Ppl firing a mortar firstly have to aim it. Then they have to load it. If you aim it at a target and that target moves, or is killed... you don't just load it anyway, firing at where the target was...that is stupid.

The mortar shell doesn't magically disappear if whilst it's in the air the target is killed... once it's been fired, it goes to it's target...it's the aiming that's the issue, and something you appear to be struggling with.

SERIOUSLY WHEN WILL SUPERCELL FIX THIS!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


I know its been raised before and will be again. However, this is just a moan!

Some complete noob just robbed half my ♥♥♥♥ because apparently my base is really, really, really good at killing individual troops before my Wizard Tower can fire....so frustrating! This attack would have been stumped completely if the tower worked as it should.

♥♥♥♥

i completely hear you. One tip have you maxed out your mortar i found maxing mine really helped because if your wiz tower doesn't hit your mortar should and vice versa.

Hmmm wrong sub forum?

Quote:

---

Originally Posted by Fakhouri

Hmmm wrong sub forum?

---

Not really, this was a rant not a Bug & Problem report. Well, yes it is a pretty big ♥♥♥♥ing problem but its been mentioned before.

This isn't a joke...there should really be a complaint (A.K.A. Whiners) sub-forum

Quote:

---

Originally Posted by Djemerson13

This isn't a joke...there should really be a complaint (A.K.A. Whiners) sub-forum

---

I have been advocating that for a while now. Had my hopes up this morning ;)




Side note: Nice avatar and sig OP.

Quote:

---

Originally Posted by zachUVA

Side note: Nice avatar and sig OP.

---

Thanks!

On topic: I'm not normally a whiner but TBH this particular issue is just awful to watch on replay. I almost faceplamed my self to the moon!